When configuring an IPX system with more than one network switch, bandwidth calculations must be performed to ensure that your uplinks do not get saturated. For example, if you have two switches with ...
If you have used a Raspberry Pi with a VLX, you may have noticed that the VLX will always switch to the Pi as the active input when it reboots, even if auto-sense is disabled. This happens because th...
If a VLX's firmware becomes corrupt due to a failed update and becomes inaccessible on the network, you may be able to recover it by entering secondary firmware mode. For VLX-TCW2V-C and VLX-TCW2H-C, ...
Channel mapping is a feature that allows you to assign VLX streams to a virtual channel, much like a TV tuner. Once enabled, you can use the channel up/down buttons on the Aurora IRC-11 IR remote con...
For point-to-point applications, you can set two VLX units to stream without a switch. Option 1: Match Encoder Host ID to Decoder Host ID: Note the Host ID of the decoder (Last for digits of serial nu...
With VLX, we use a generic EDID that allows a 4K input to pass through to the decoder. In some cases when the EDID is not sent, you may get discoloration, sync issues or no audio. There are a couple d...
With IPX, we use a generic EDID that allows a 4K input to pass through to the decoder. In some cases when the EDID is not sent, you may get discoloration, sync issues or no audio. To send EDID with I...
To send hex values via IPBT Mgr serial, here are the available commands: The parser shall check for the following sequence of characters in the receive packet and replace with respective hex code and ...
NOTE: The following article pertains to VLX firmware versions prior to 3.20.0. For 3.20.0 and newer, please refer to the update at the bottom of this article. The VLX transceiver provides an API comm...
You may choose to use 1G-POE switch to power your IPX Design. In this design, it's possible network loop occurs. This causes video failure. There is an IPX setting under the Ports tab to break the 1...